Biomass Flue System
125mm (5”) vertical conventional stainless steel, twin wall insulated
Specifically designed for use with GRANT NI pellet boilers.
It has been fabricated to cope with continuous operating temperatures of up to 200°C although the typical flue gas temperature produced by GRANT NI biomass boilers is less than 80°C. The system is designed so that the stainless steel outer case is load bearing and stainless steel inner liner is free to expand independently to accommodate temperature change. Available with a range of extension pieces and bends, the system can easily be assembled to suit a wide variety of installations.
- Twist-lock bayonet jointing system including seals, secured by locking bands.
- Advanced corrosion resistant design and construction uses laser welded stainless steel inner liner and case.
- The 25mm high efficiency Superwool blanket maintains flue gas temperature, maximising efficiency, improving flue draught on start up and minimising condensation.
- Low external case temperature.
- Inner liner held by the male locking collar but free to expand and contract with temperature by up to 18mm through the female collar.
- The inner liner has an inward bead at the female end which acts as a capillary break preventing moisture being drawn through the joint.
- CE certified denotes it is fully compliant with the new regulations in force from 1st July 2013.
Biomass flue system components are joined together by placing the female collar of one section over the corresponding male collar of the preceding section then locking by rotating the upper section clockwise. It is vital that all flue components are installed with the male collar pointing upwards. An arrow on the label indicates the flue gas direction.
The inner of each section is enlarged at the male end so that the female end of the other section or fitting enters into it and overlaps. This allows any condensation to run back to the boiler without escaping from joints.
The flue should remain as straight as possible through its vertical run to assist flow. Should it be necessary to angle the flue run, an offset no greater than 45° to the vertical flue. A vertical rise of 600mm should be allowed immediately above the appliance before any offsets. Flue systems should be installed in accordance with Building Regulations.
Only the Grant Biomass flue system can be used with Grant pellet boilers, as it has been designed to enable efficient operation and reliability. Failure to comply with the above, may result in the guarantee becoming invalid.
A maximum of two 45° bends should be used in the flue run. This can be increased to a maximum of four between the boiler and the terminal if an inspection hatch is fitted between the second and third elbows.